Celle di carico idrauliche per tiranti
Codici di riferimento: L2M0, L2E0 LE CELLE DI CARICO L2CE SONO STATE PROGETTATE PER REGISTRARE I CARICHI SOPPORTATI DALLE CENTINE (SIA AL PIEDE CHE TRA LE PIATTABANDE DI GIUNZIONE) E DAI PUNTONI. Sono essenzialmente costituite da due piatti in acciaio saldati lungo il loro perimetro e separati internamente da una cavità saturata sotto vuoto con […]
Centro per il monitoraggio dell’impatto delle infrastrutture sull’ambiente
Grazie ai finanziamenti europei, all’interno dell’Università Tecnica di Bucarest è stato creato un Centro per il monitoraggio dell’impatto delle infrastrutture sull’ambiente.Gara Internazionale che è stata vinta da SISGEO. L’obiettivo era quello di fornire all’Università Tecnica la strumentazione geotecnica necessaria per permettere agli specialisti dell’Università di gestire differenti progetti in Romania. Oltre alla fornitura della strumentazione, […]
Monitoring works for the 2014 Sochi Winter Olympic Games – Russia
Sisgeo, thanks to the collaboration with its Russian partners AGT Systems and GPIKO, furnished and installed all the equipments necessary to monitor the most important road and railway works that are under construction in Sochi area, that is the neural centre of 2014 Winter Olympics.The monitored works are: retaining walls for the protection of roads, […]
Cleaning-up project of Panama City and Bay
The cleaning-up project of Panama City and Bay includes: Construction of Health Service networks Construction and rehabilitation of Collectors and Drive lines Interceptor system Plant for wastewater treatment. These elements will be developed to collect, transport and treat wastewater of Panama City which is currently discharged directly into the bay or rivers and streams in […]
FAQ#034 – Is possible to repair/change the manometer without disassemble the load cell?
It is not possible to repair/change the manometer without disassemble the load cell. The scope of the glycerine inside of the manometer display is only to show eventual tampering of the manometer. The load cell work properly without glycerine, too.
FAQ#015 – The anchor load value displayed on the load cell manometer or readout does not agree with load calculated by the hydraulic jack. What’s right?
The main factors which influence the anchor measurements are: – axial misalignment of the jack– difference in diameter between the jack and the load cell. These factors cause bending of the bearing plate between the load cell and the jack and affects the response of the cell. To minimise this effect use the genuine distribution […]
